Publicidad
③
④
⑥
⑦
①
③
⑤
⑦
22
English
⑤
To replace the left chinstrap cover (D-ring side), ensure the female chinstrap
end snap side of the chinstrap and the leatherette side of the chinstrap
cover both face outward, slip the chinstrap cover onto the chinstrap ③& ④.
Position the plastic chinstrap anchor cover over the steel anchor and push the
cover in the anchor until the tab on the back of the cover snaps fully home ⑤.
To replace the right chinstrap cover (long side), ensure the cap side of the
⑧
chinstrap end snap (Arai logo impressed) on the chinstrap and the leatherette
side of the chinstrap cover both face outward, slip the chinstrap cover onto
the chinstrap ⑥& ⑦. Position the plastic chinstrap anchor cover over the
steel anchor and push the cover in the anchor until the tab on the back of the
cover snaps fully home ⑧.
②
TO REMOVE/REPLACE NECKROLL
First remove the cheekpads as per previous instructions.
To remove, pull out the neckroll end tabs, which are inserted into the chin center
pad at both sides ①. Grasp center of the neckroll firmly ②, rotate it to either
direction by 3cm – 4cm (1-1/4" – 1-1/2") ③and remove it from the helmet ④.
④
To wash the neckroll, put it into lukewarm water with small amount of laundry
soap or your own shampoo and wash gently by hand. Rinse well with fresh
water and wipe off with a soft cloth. Dry it in the shade at ambient temperature.
WARNING: Never use petrol, thinner, benzene or any other solvents.
⑥
To replace, insert the neckroll frame into the slot of the helmet ⑤, centering
the neckroll on the helmet ⑥. Further insert the frame so that the 3 tabs on
the frame are locked in the slot of the helmet ⑦.
⑧
Replace the neckroll end tabs ⑧, and replace the cheekpads
Publicidad
Capítulos
