Publicidad
①
4
②
③
④
English
TO OPEN/CLOSE SHIELD
To open, push the shield latch lever up and the shield will open slightly ①.
Then pull the bulge on the shield slightly outward so the shield clears the latch
post on the helmet ②, and raise the shield.
WARNING:
Do not attempt to open the shield without using the latch
system, or push down on the shield latch lever ③, as damage to the latch
system may occur.
To close, push the shield down until the latch post fully engages the shield
and the latch lever captures the bottom of the shield ④.
WARNING:
Be sure to latch the shield properly before riding. If not
latched securely, the shield may open unexpectedly from wind pressure,
vibration or even normal head movement.
WARNING:
If your shield becomes too scratched or uncleanable, replace it
with a new one. Impaired visibility causes accidents. Use a solution of mild soap
or detergent and lukewarm water to clean your shield. Rinse well with clean
water, and wipe off with a soft cloth. Never use petrol, thinner, benzene or any
other solvents. There are many "aggressive" cleaners on the market, including
some supposed to be specifically for use on shield. Arai strongly recommends
that you do not use any such products to clean your shield as some of their
ingredients may have damaging effects on the shield and other plastic parts
installed on your helmet. Do not apply stickers or adhesive tape to the shield, as
this will weaken the hard coating. If tinted, the shield is for daylight use only.
Publicidad
Capítulos
