Milwaukee 6391 Manual Del Operador página 6

Sierra circular de cuchilla izquierda para trabajo pesado con empuñadura tilt-lok
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. To install a blade, place
the blade on the spin-
dle with the teeth point-
ing in the same direc-
tion as the arrow on the
lower guard. Larger
diameter of inner flange
should rest on blade.
Release the lower
guard lever.
5. Place the outer blade flange on the spindle and
hand tighten the bolt. Larger diameter of outer
flange should rest on blade.
6. While holding the spindle lock button in, use the
wrench to turn the bolt counterclockwise and tighten.
Adjusting Depth
1. Unplug tool.
2. To adjust the depth of the cut, hold the saw by the
Tilt-Lok™ handle and loosen the depth adjust-
ing lever by lifting it up and away from the shoe.
3. Raise or lower the shoe to the desired position.
Markings in 1/4" increments are located on the
inner side of the upper guard for depth setting. For
the proper depth setting, the blade should extend
no more than 1/4" below the material being cut.
4. Move the depth adjusting lever towards the shoe
and push down to secure the position.
Inner flange
Outer flange
6
Adjusting Bevel Angle
1. Unplug tool.
2. To adjust the angle
of the cut, hold the
saw by the Tilt-
Lok™ handle and
loosen the bevel
adjusting lever by
lifting it up towards
the blade.
3. Hold the front han-
dle and rotate the
saw by the Tilt-Lok™
handle to the de-
sired angle as indi-
cated by the mark-
ings on the bevel
scale.
4. Move the bevel ad-
justing lever away
from the blade and
push down to se-
cure the position.
Adjusting Tilt-Lok™ Handle Angle
This circular saw is equipped with an adjustable han-
dle. The Tilt-Lok™ feature allows the user to adjust
the angle of the handle for optimum cutting positions.
1. Unplug tool.
2. Press in and hold the handle lever release button.
3. Loosen the handle release lever by lifting it up and
away from the Tilt-Lok™ handle.
4. To adjust the handle position, hold the front handle
and rotate the Tilt-Lok™ handle to the desired
angle as indicated by the handle rotation adjust-
ment markings. The Tilt-Lok™ feature has eight
(8) detents which allow the handle to snap into
position. Allow the detent to snap into place.

Publicidad

Tabla de contenido
loading

Tabla de contenido