EHEIM LOOP Serie Manual De Instrucciones página 14

English
Installing the pump connection (⌦D)
1. Connect the spiral hose ③ of the pump to the connecting piece ①.
2. Insert the sealing washer ② into the connecting piece.
3. Screw the connecting piece onto the UVC clarifier with the union nut.
Connect the outlet hose (⌦E)
1. Use a saw to shorten the outlet spigot to the diameter of your hose.
2. Connect your hose to the outlet spigot.
We recommend fastening the hoses with hose clamps
5. Operation
Attention! Electrocution!
▶ The device's safety distance from the water must be at least 2 m.
Caution!
▶ Heed the operating manual for the UVC clarifier and the pump, especially the chapters on safety,
commissioning and operation.
1. Place the filter on the pond bank (⌦F).
2. Place the pump on a solid surface as horizontal as possible in the pond so that the filter housing
of the pump is covered by at least 20 cm of water. Pay attention to the maximum pond depth (see
Technical data).
Switching on the pump and UVC clarifier
1. Insert the respective mains plug into the mains socket.
Attention: The pump starts immediately!
Switching off the pump and UVC clarifier
1. Remove the respective mains plug from the mains socket.
6. Maintenance
Attention! Electrocution!
▶ Before all maintenance work, disconnect the mains plugs of the pump and the UVC clarifier.
Caution!
▶ Heed the operating manual for the UVC clarifier and the pump, especially the chapters on safety and
maintenance.
Caution! Material damage.
▶ Do not use hard objects or aggressive cleaning agents for cleaning.
The following sections describe maintenance work necessary for optimum and fault-free operation.
Regular maintenance prolongs the service life and assures functionality of the filter over a long period.
14