Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Intended Use
This appliance serves for heating, grilling and browning of food.
It is intended for the use in private households and similar appli-
cations. The appliance is only to be used as described in the
user manual. Do not use the appliance for any other purpose.
Any other use is not intended and can result in damages or
personal injuries.
The manufacturer assumes no liability for damages caused by
improper use.
Scope of Delivery
2 Attachable grilling frames
1 Turnable aluminium die cast plate
1 Natural stone
8 Pans
8 Wooden spatulas
Unpacking the Appliance
•
Remove the appliance from its packaging.
•
Remove all packaging materials such as films, filler materi-
al, cable clips and carton.
•
Check the contents for completeness.
•
Check the appliance for possible transport damage to
prevent hazards.
•
In case of incomplete delivery or damage, do not operate
the device. Return it to your dealer immediately.
NOTE:
Production residue or dust may have collected on the appli-
ance. We recommend cleaning the appliance according to
chapter "Cleaning".
Instructions
CAUTION: Avoid damage to the non-stick coated
grill surfaces!
•
Only use a wooden or Teflon spatula.
•
Do not use pointed objects (e.g. knife, fork) on the grill
surface.
•
Do not use plastic utensils. They can melt.
•
The non-stick coated grill surfaces enable dishes to be
prepared without the use of fat.
•
If you want to use oil, ensure that it is highly heatable oil,
such as sunflower oil. Do not use olive oil or butter, as they
start smoking at a low temperature.
Assembly
•
Do not plug the appliance to assemble it.
•
Place the docking station on a flat, stable surface.
•
Place the other half of the frame on the contact point of
the docking station. Push the two docking points together
gently.
30
•
Place the aluminium die cast plate on the frame (choose
the flat side or grill side), or use the natural stone.
•
Both frames may now be turned to a 180° angle.
•
Place the small pans underneath.
•
The two frames may be used together, or separately, by
using the two ON / OFF switches located on each frame.
CAUTION:
During baking / grilling, the frames shall not be removed from
the docking station.
NOTE:
The docking station can be used as a 4 person raclette.
Electrical Connection
•
Please ensure that the ON/OFF switches are set to position
"O".
•
Before you plug the power plug into the power outlet,
ensure that the mains voltage corresponds with that of the
appliance. You can find information about this on the rating
plate.
•
Only connect the appliance to a properly installed earthed
socket.
Switching ON/OFF
The switches are used to switch the appliance on and off. The
lights on the switches show that the appliance is on. 'O' is OFF,
and 'I' is ON.
Before Initial Use
1. Slightly grease the small pans and the aluminium die cast
grill plates / natural hot stone.
2. Put all the parts into the appliance.
3. Operate the appliance without food for about 15 minutes
for the protective layers to be removed. To do so, turn the
switches to the ON setting "I".
NOTE:
This process normally produces a small amount of
smoke. Ensure adequate ventilation.
4. Turn the switches to the OFF setting "O". Disconnect the
mains plug from the wall socket.
5. Let the appliance cool down completely.
6. Clean all the parts that will come into contact with food
again.
CAUTION: Attention please!
When using the appliance it becomes hot. Only touch the
ON/OFF switches. The turnable die cast plates and/or natural
stone may not be removed or reversed before the appliance
is entirely cooled.
Publicidad
Tabla de contenido
