Festool Charger; Changing Direction Of Rotation - Festool IMPACT TI 15 Manual De Instrucciones

TI 15
GB
< 15 %
Recommendation: Charge
battery pack before further
use.
6.2

Festool charger

Charging the battery pack [3]
Charge Festool battery packs only us-
ing an original Festool chargerTRC 3.
The charger TRC 3 can be used to charge all
Festool battery packs of the BPS and BPC se-
ries. The charger automatically detects the
type of the inserted battery (NiCd, NiMH or
LiIon). A microprocessor controls the charg-
ing process in line with the charging state,
temperature and voltage of the battery pack.
The LED [3-2] on the charger indicates the
respective operating status of the charger.
LED yellow - lit continu-
ously
Charger is ready to use.
LED green - flashing
quickly
Battery pack is charged to
maximum capacity.
LED green - flashing
slowly
Battery pack is charged with
reduced current. LiIon is
charged to 80 %.
LED green - lit continu-
ously
Charging is complete or is not
restarted as current charge
status is greater than 80%.
LED red - flashing
General fault display, e.g.
incomplete contact, short cir-
cuit, defective battery pack,
etc.
LED red - lit continuously
Battery temperature is out-
side the permitted range.
Charger wall mount
The charger TRC 3 has two elongated holes
on its back. It can be mounted on a wall us-
ing two screws (e.g. round head or flat head
screw with shank diameter of 5 mm) (see
Fig. [3]).
16
7 Settings
7.1

Changing direction of rotation

[1-3]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise ro-
tation
7.2 Adjust speed/impact rate
CAUTION
Damage to screw and/or workpiece
X
Adjust the speed/impact rate and impact
duration to the specific application.
X
Adjust the speed/impact rate at thumb-
wheel [1-6]:
Setting 1 = low speed/impact rate
Setting 6 = high speed/impact rate
8 Tool holder, attachments
WARNING
Risk of injury, electric shock
X
Always disconnect the battery pack before
any type of work on the machine!
Festool offers attachments and tool holders
for various applications.
8.1 Tool chuck CENTROTEC WH-CE
[4]
The tool chuck CENTROTEC WH-CE allows
you to change tools with a CENTROTEC
shank in a matter of seconds.
L Always use a CENTROTEC tool chuck to
clamp CENTROTEC tools.
CAUTION
Tool has sharp edges and can cause cut-
ting injuries during a tool change.
X
Wear protective gloves!
8.2 BF-TI 13 chuck [5]
The BF-TI 13 chuck is used for clamping drill
bits up to 13 mm and shaft tools.
L Impact mode is automatically switched off
when the chuck is inserted.