Operating Modes; Acoustic Warning Signal - Festool IMPACT TI 15 Manual De Instrucciones

CAUTION
Risk of injury
X Clamp the tool centrally in the chuck!
X
Pull the sleeve back to clamp the drill bit
and turn this in a clockwise direction until
it locks in.
8.3 TI-FX adapter [6]
The TI-FX adapter (sometimes an accessory)
makes possible the fitting of the following at-
tachments on the power tool.
L Impact mode is automatically switched off
when the adapter is inserted.
X Place the three white points in a row when
positioning the adapter. If necessary, the
hexagon socket holder must be turned
manually so the adapter can be fixed.
X Turn the clamping ring as far as the stop
to secure the adapter.
Angle attachment DD-AS [7]
The angle attachment DD-AS (in part, addi-
tional equipment) permits drilling and screw-
driving at a right angle to the machine.
Eccentric attachment DD-ES [8]
The eccentric attachment (in part, additional
equipment) permits screwdriving near edges
with bits according to DIN 3126.
9 Working with the machine
9.1

Operating modes

Depending on the tool holder / adapter se-
lected, the machine is operated as follows:
Screwing with impact
– WH-CE CENTROTEC tool chuck (see
Chapter 8.1)
Screwing and drilling without impact
– TI-FX adapter (see Chapter 8.3)
• DD-AS elbow adapter
• DD-ES eccentric attachment
• DD-DC
ment
– BF-TI 13 chuck (see Chapter 8.2)
screwdriver attach-
9.2 On/Off switch [1-2]
WARNING
Risk of injury
X Only attach the power tool to the screw
when switched off.
Press = ON, release = OFF
L Depending on the pressure applied to the
ON/OFF switch the speed/impact rate can
be controlled continuously.
The LED lamp [1-4] lights up when the on/
off switch [1-2] is pressed and lights up the
working area.
9.3 Bit store [1-1]
The magnetic bit store is designed for hold-
ing bits or bit holders.
9.4 Belt clip [1-9]
The belt clip makes possible short-term fix-
ing of the device to work attire. The belt clip
can be moved to the right or left or can also
be detached from the battery pack.
9.5

Acoustic warning signal

Acoustic warning signals sound and the ma-
chine switches off in the following operating
states:
Battery flat or machine
overloaded.
peep ― ―
– Change the battery.
– Place the machine under re-
duced stres.
Machine is overheating.
– You must allow the machine
peep peep ―
to cool before using again.
LiIon battery pack is faulty
or has overheated.
peep peep peep
– Once the battery pack has
cooled, perform a functional
check using the charger.
TI 15
GB
17