Function Of The Unit; Overview (A); Working Notes; Changing The Battery - Rothenberger ROCAM 4 Plus Instrucciones De Uso

4

Function of the Unit

4.1 Overview
Camera head
1
Positioning probe
2
Bending spring
3
Reel cable
4
Rear flap
5
Front flap
6
4.2

Working notes

- Do not bend the reel cable! The cable may break!
- Do not pull the reel cable over sharp edges! The cable may become damaged!
ATTENTION! Always protect ROCAM 4 Plus against water, and use only rec-
ommended indoors. Only the camera head (1) and reel cable (4) may come
into contact with water!
4.3

Changing the battery

Open the rear cover (5).
Insert the battery into the compartment on the right side of the accessory compartment until
it clicks. To remove, press the locks and pull the battery out.
4.4

Working with the device

Wear protective clothing! Always stand next to the reel cable!
Push reel cable (4) with bending spring (3) from the holder (10) / reel (8) take and remove
cap.
Remove the cap from the camera head (1) and screw on the bending spring (3).
Caution: Check for cleanliness and damage!
If necessary, additional accessories can be attached to camera. When using pipe diameters
greater than 70 mm, always use guide body!
Clean the pipe system before inspection.
Press button on the bottom cover (6), open the cover. Hold the door during opening.
Turn the device on with the Power-button, located bottom front center of the monitor (7). The
monitor unit (7) can be removed from the basic device for optimal viewing angle.
Excessive pressure on the touch screen may damage the monitor unit!
Remove the camera head (1) from the holder (10) and pull the cable (4) from the reel (8).
The cable is rigid and is under mechanical stress. Therefore, hold it firmly when unwinding
from the reel. By pressing in the holder / bracket (10), it can be clamped!
Guide the camera head (1) into the pipe system and carefully push it with the cable (4). Cau-
tion: Unwinding the reel too quickly may cause it to continue to spin.
For optimal results, a camera head (SL40) with a stronger light yield up to DN300 can be
screwed on. Camera heads are interchangeable.
Do not pull the cable (4) over sharp edges, and do not bend it!! Check the camera
cable before each use for damage!
While it is being pushed, the cable (4) may loop: Breakage may result!!
26
Monitor unit
7
Reel
8
Frame
9
Holder / Bracket
10
Guide hook
11
ROCAM 4 Plus - AC - adapter
12
ENGLISH
(A)