Foppapedretti Energy Manual De Instrucciones página 20

• ENGLISH •
ASSEMBLY
Position the seat frame as shown in the figure, placing the joint with the control panel on the left side of the
seat. Attach the seat support arms (1) and (2) to the corresponding joint, inserting the metal pin into the
respective slot as shown in the figure. Once installed, insert the round locking washer (a) onto the metal pin, as
shown in the figure, with the larger diameter facing the joint. Pressing, completely slide the round washer onto
the pin, until it touches the joint, then insert the pin cover cap (b) and the covering cap (c). Repeat this assembly
process also on the pin of the opposite joint. Once this is complete, check that it has been assembled correctly
by pulling the seat frame inwards: the arm must not disengage from the joint.
a
b
1/2
c
1 2
As shown, insert the two ends of the toy bar into the appropriate slots on the seat frame.
20