Follow the operations shown in the figures to attach the chest straps on the rear side of the backrest.
Upper
Lower
loop
loop
Place the child in the seat as shown in figure. Insert the left and right sets of straps into the restraint latch. A
"click" will indicate the correct fastening. Adjust the harness to fit the height of your child, using the restraint
fits. The harness should fit snugly but not too tightly. The right regulation should allow to insert a
Slide the buckle left/right to adjust the waist harness length
Press the buckle button to level the waist harness
IMPORTANT: Adjust the chest belts according to the height of your child. The straps must pass through the
slots closest to the height of the child's shoulders. In the backrest there are 3 pairs of slots that can be used to
adjust the straps according to the height of the child.
IMPORTANT: Both the chest belts, jutting out from the back rest, have coincide with the height of the shoulders
of the child and be at the same height. Always secure the child with the restraint latch correctly adjusted and
hooked/locked.
• ENGLISH •
HARNESS BELT FASTENING
Thread the strap
into the upper loop
IN USE
Slide the buckle up/down to adjust the waist
harness length
Fold the strap and
insert it into the
lower loop
21
Tighten the strap
to lock it
finger.