Identification Label; Main Components; Assembly; Assembly Components - Stiga ST 4262 P Manual De Instrucciones

DANGER! Danger of fire or
explosion. Do not smoke, do not use
open flames or ignition sources
DANGER! Wear personal
ear protectors.
DANGER! Wear goggles.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an Authorised Service Centre.

3.3 IDENTIFICATION LABEL

The identification label contains
the following data (fig. 1 ):
1. Manufacturer's address
2. Type of machine
3. Acoustic power level
4. CE conformity marking
5. Engine's operating rotation speed
6. Engine power
7. Engine displacement
8. Month / Year of manufacture
9. Serial number
10. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Specify the identification
names on the product identification label.
IMPORTANT Use the identification
names whenever contacting an
Authorised Service Centre
IMPORTANT An example of the
Declaration of Conformity is provided
on the last pages of this manual.

3.4 MAIN COMPONENTS

The machine is composed of the
following main parts (fig. 1 ):
A. Chassis
B. Dashboard
C. Engine
D. Fuel tank
E. Plug for electrical starting
F. Manual starting grip
G. Deflector
H. Discharge chute
I. Paddle
J. Auger protective cover
K. Auger
L. Levelling shoes
M. Headlights (optional)
N. Wheels/Tracks
O. Auger extension (optional)

4. ASSEMBLY

For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
indications provided in the "ASSEMBLY"
section have been carried out.
IMPORTANT The machine is supplied
without engine oil or fuel.

4.1 ASSEMBLY COMPONENTS

The packaging includes the components (fig. 3 )
needed for assembly as listed in the table below:
ST 526 S, ST 625, ST 665, ST 665 T, ST 726 T
Pos. Description
A Gear lever
B Screws for fixing the gear lever
C Spacers with screws for
fixing the handle
D Gear lever grips and deflector guide
E Funnel
F Safety key
G Discharge chute
H Screws and self-locking nuts
Pos. Description
A Gear lever
B Screws for fixing the gear lever
C Spacers with screws for
fixing the handle
D Gear lever grip
E Funnel
F Safety key
G Discharge chute
H Screws and self-locking nuts
The Auger extension
EN - 5
ST 767 H
Qty.
1
-
2
2
1
1
1
3 + 3
Qty.
1
-
2
1
1
1
1
3 + 3
1