Product Identification Label; Main Components; Assembly - Stiga ST 700 Li 4 Serie Manual De Instrucciones

PROJECTION HAZARD! Keep
any people or pets at least 15 m
away when using the machine!
DANGER! Before servicing
the machine, remove the
battery from the machine.
WARNING! As regards the
battery and the battery charger,
consult the relative manual
SAFETY INSTRUCTION
Damaged or illegible labels must be replaced.
Order new labels from your authorised service
centre.

4.3 PRODUCT IDENTIFICATION LABEL

The product identification label provides the
following data (Fig. 1):
1. Manufacturer's address
2. Conformity marking
3. Type of machine
4. Sound power level
5. Power supply voltage
6. Month / Year of manufacture
7. Serial number
8. Article code
9. IPX4
Write the identification data of the machine in the
specific space on the label on the back of the
cover page.
SAFETY INSTRUCTION
Always refer to the information provided
on the product identification label when
contacting the authorised workshop.
NOTE
A sample of the declaration of conformity
can be found at the end of this manual.

4.4 MAIN COMPONENTS

The machine is composed of a series of
main components that have the following
functions (Fig.1 ):
A. Handle: enables the steering of the machine.
B. Starter lever: enables the start-up and shut-
down of the machine.
C. Release button: prevents the starter lever
from being activated accidentally
D. Chute
movement of the snow chute.
E. LED lights: provide a better vision while
working.
F. Quick release grips: allow the closure of the
handle joint.
G. Central handle.
H. Lower handle.
Discharge chute: opening for snow ejection
I.
J. Deflector: allows the outflow of snow to be
directed.
K. Scraper: it allows to remove the snow
residues from the ground.
L. Impeller mechanism that launches the snow.
M. Battery compartment: battery housing seat
N. Battery: (if it's not supplied with the machine,
see chapter 15 "accessories on request"):
device that supplies electrical current to the
tool; its specifications and regulations for use
are described in a specific manual.
O. Battery charger: (accessory on request,
par. 15.2): device used to recharge the
battery; its specifications and regulations for
use are described in a specific manual.

5. ASSEMBLY

CAUTION
Safety regulations to be followed are outlined in
chapter 2. Strictly comply with these indications to
avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly should
be done on a flat and stable surface, with enough
space for machine handling and its packaging,
always making use of suitable equipment. Do not
use the machine until all the indications provided
in the "ASSEMBLY" section have been carried out.
EN - 8
adjustment handle: enables