Attaching Rip Fence - Skil 3700 Instrucciones De Funcionamiento Y Seguridad

Attaching Rip Fence

1. Raise rip fence handle T18 as shown (Fig. 14), so holding
clamp is out far enough to fit on the table.
2. Position the rip fence T3 over table, holding up the front end
while engaging rear, then lowering front end onto rail engaging
the Digital Display T5. (Fig. 15)
3. For proper alignment of rip fence, refer to Aligning Rip Fence
section on page 70.
Attaching Handle to Elevation
Wheel
1. Attach handle to wheel using bolt as shown in figure 16.
FIG. 14
FIG. 14
FIG. 15
FIG. 16
48.
T3
T3
T5