Assembling The Blower - Stihl BGE 61 Manual De Instrucciones

English

Assembling the Blower

N
Disconnect the plug from the power
supply.
Mounting the Blower Tube (BGE 61)
2
5 4
3
6
N Line up the recesses. The arrow (2)
must be on the top of the blower
tube (1).
N Push the blower tube (1) into the fan
housing stub (3) as far as the stop.
N Push the union nut (4) over the fan
housing stub (3) and turn it in the
direction of the arrow until the tab
(5) engages the opening (6) in the
union nut.
Mounting the Blower Tube (BGE 71)
Your BGE 71 can be switched on only
when the blower tube is properly
mounted. The union nut activates a
switch which closes the circuit to allow
the motor to be switched on.
10
2
4
3
N Line up the recesses. The arrow (2)
must be on the top of the blower
tube (1).
N Push the blower tube (1) into the fan
housing stub (3) as far as the stop.
N
Push the union nut (4) over the fan
housing stub (3) and turn it in the
direction of the arrow as far as the
stop. You will hear the safety switch
being activated.
Mounting the Nozzle
6
N
Push the nozzle (5) onto the blower
tube (1) as far as lug (6),
position (a) (long) or position (b)
(short), and rotate the nozzle in the
direction of the arrow to it lock in
position.
Removing the Blower Tube (BGE 61)
N Shut off the engine.
N Insert a suitable tool through the
opening in the union nut to press
down the tab.
N Rotate the union nut (4) in the
direction of the arrow as far as the
stop.
N Remove the blower tube (1).
Removing the Blower Tube (BGE 71)
a b
N
Shut off the engine.
N Rotate the union nut (4) in the
direction of the arrow as far as the
stop.
N Remove the blower tube (1).
4
4
BGE 61, BGE 71