Connecting To Power Supply - Stihl BGE 61 Manual De Instrucciones

English
5
N Push the union nut (4) over the
intake opening.
N Line up the arrows (3 and 5).
N Rotate the union nut (4) in direction
of arrow until the lever (6) engages
audibly on the fan housing.
Removing the Elbow
1
N Shut off the engine.
N Rotate the union nut (1) in the
direction of the arrow as far as the
stop.
N Remove the elbow (2).
12
Removing the Suction Tube
N Switch offf the motor.
N Operate the lever (1), rotate the
union nut (2) in direction of arrow as
far as the stop and remove together
with the suction tube.
4
5
N Position the intake screen (3) on the
intake opening.
N Line up the arrows (4).
N Rotate the intake screen nut (3) in
direction of arrow until the lever (5)
engages audibly on the fan housing.
Connecting to Power
Supply
Make sure your cord set is in good
condition. When using an extension cord
set, be sure to use one heavy enough to
carry the current your product will draw.
An undersized extension cord set will
cause a drop in line voltage resulting in
loss of power and overheating. The table
below shows the correct size to use
depending on cord length and
nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Minimum wire gauge for extension cords
for 120 Volt appilances using 6 - 10
Amps (Cord types SJW or SJTW):
Cord length (ft) Wire gage (AWG)
50 16
100 14
150 12
Appropriate extension cords are
available in special stores for electrical
equipment or from your STIHL dealer.
2
1
N
Insert the appliance plug (1) into
extension cord coupling (2).
BGE 61, BGE 71