Adjusting The Pendulum Stroke; Working With The Electric Power Tool - Festool CARVEX PSC 420 EB Manual De Instrucciones

English
Assembly is performed in reverse se­
quence to removal. Ensure that the saw
table is firmly seated in the guide.
Instead of the saw table, the WT-PS 400 angle
table or ADT-PS 400 base adapter can be instal­
led at the support.
Never saw without the saw table, or one
of the other tables or adapters offered in
the Festool accessories range.
9.5 Extraction
WARNING
Health risk due to dust
► Always work with an extractor.
► Comply with national regulations.
The extraction adapter [6-3] allows jigsaws to
be connected to a dust extractor (hose diameter
1-1/16" (27 mm)).
► Insert the extraction adapter in the rear
opening of the saw table so that the
hook [6-2] engages in the recess [6-1].
► To remove the extraction adapter, press the
hook [6-2].
Due to the low power consumption of the
machine (low energy consumption), dust
extractors with an automatic switch-on
function will sometimes only start up when
the actual cut is made.
► Set the dust extractor to continuous opera­
tion for special applications (e.g. low stroke
rate, soft wood).
9.6

Adjusting the pendulum stroke

In order to saw different materials with the
proper rate of advance the pendulum stroke
can be adjusted. Set the required stroke via the
pendulum stroke switch [1-12]:
Position 0 = pendulum stroke disabled
Position 3 = maximum pendulum stroke
14
6-2 6-3
6-1
Recommended pendulum stroke setting
Softwood, chip board, wood fibreboard
Blockboard, plywood, plastic
Ceramics
Aluminium, non-ferrous metals
Steel, hardwood
9.7 Stroke rate control
Using the adjusting wheel [1-6], the stroke rate
can be continuously adjusted between 1500 and
3800 min (PSBC 420 EB: 1000–3800 min
-1
This enables you to optimise the cutting speed
to suit the respective material.
Automatic load detection is activated in posi­
tion A: The stroke rate drops when idling and is
adjusted to the highest setting when the work­
piece is introduced.
Recommended stroke rate (position of the ad­
justing wheel)
Hard and soft wood, blockboard, ply­
wood, chipboard
Fibreboard
Plastic
Ceramic, aluminium, non-ferrous met­
als
Steel
10 Working with the electric
power tool
6
Materials which produce a lot of dust
Damage to the machine due to the ingress of
dust, risk of injury
► Do not work overhead.
Risk of injury
► With the tool switched off and unplugged,
check for tight fit of the sawblade before
starting to work
► Always apply the pendulum jigsaw to the
workpiece with the sawblade running.
► Wait until the power tool stops completely
until placing it down. The tool can become
entangled and lead to a loss of control of
the power tool.
CAUTION
WARNING
1 - 3
1 - 2
0
0 - 2
0 - 1
).
-1
A
4–A
3–A
3–5
2–4