Cleaning The Chip Ejection Opening; Accessories; Sawing With Special Base Runners; Sawing With The Angle Table - Festool CARVEX PSC 420 EB Manual De Instrucciones

English
Always use original Festool spare
EKAT
4
parts. Order no. at: www.festoolu­
sa.com/service
5
3
2
1
11.1 Observe the following information
► Check the guidance roller regularly for
wear.
► Regularly remove dust deposits from the
chip guard.
► Regularly clean the base runner to prevent
scratches and cores on the surface.
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
► To ensure constant air circulation, always
keep the cooling air openings in the motor
housing clean and free of blockages.
► Keep the contacts on the power tool, charg­
er and battery pack clean.
► Check all warnings on the electric power
tool for readability and completeness. Re­
place missing or illegible warnings.

11.2 Cleaning the chip ejection opening

Clean the chip ejection opening [1-14] regularly
to prevent blockages:
► Remove the chip guard.
► Use a brush or vacuum cleaner to clean the
chip ejection opening.
► Reinsert the chip guard.
Check all warnings on the electric power tool
for readability and completeness. Replace
missing or illegible warnings.

12 Accessories

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
Use only original Festool accessories and
Festool consumable material intended for this
machine. These components are designed spe­
cifically for this machine. Using accessories
and consumable material from other suppliers
will most likely affect the quality of your results
and limit warranty claims. Machine wear or
your own personal workload may increase de­
pending on the application. Protect yourself and
your machine, and preserve your warranty
claims by always using original Festool acces­
sories and Festool consumable material!
16
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under "www.festoolusa.com".
12.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations that are specially designed for your
Festool jigsaw.

12.2 Sawing with special base runners

The special base runners protect high-quality
surfaces against scratches and scores.
► Press in the base runner at position [7-1].
► At the same time, push the base runner for­
wards.
► Mount another base runner and push it to
the rear until it engages.

12.3 Sawing with the angle table

The WT-PS 400 angle table is used for
cutting pipes or interior and exterior an­
gles up to 45°.
Dust extraction is not possible when sawing
with the angle table!
Installing the angle table
► Remove the saw table [1-11] (see section
9.4 ).
► Position the angle table against the saw
base support.
► Close the lever [1-9].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
► Turn the adjusting wheel [8-1] to select the
required angle.
You can select the angles -45°, 0° and +45° on
the scale [8-2].
7
7-1