Environment - Festool CARVEX PSC 420 EB Manual De Instrucciones

English
118-1/8" (120 and 3000 mm). The core maker
can be installed from both sides on the base
adapter.
► Place the jigsaw with attached base adapter
on the adapter [11-1] on the core maker.
► Insert the centring mandrel [11-2] in the
hole [11-4] on the core maker aligned with
the saw blade.
► Clamp the measuring tape to the core mak­
er using the rotary knob [11-5].
Recommended settings when using the core
maker:
► Cut in an anticlockwise direction.
► Work at a slow rate of advance.
► Set the pendulum stroke [1-12] to 0–1.
► Set the stroke rate [1-6] to 1–5.
Store the centring mandrel in the depot
[11-3].
KS-PS 400
11-1
11-5 11-4
12.5 SYSTAINER
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro­
vides protection and storage for the tool and ac­
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
Turn the T-loc to this position.
To lock the Systainer
Turn the T-loc to this position.
18
To connect two Systainers
Place one Systainer on the top of the other
(Fig. ).
The Systainers are connected and locked.
A new generation Systainer is connectable
on top of a previous generation Systainer
by the four latches of the previous
Systainer.
11
11-2
11-3
SYS-b-1

13 Environment

Do not dispose of the device together with do­
mestic waste! Dispose of machines, accesso­
ries and packaging at an environmentally re­
sponsible recycling centre. Observe the valid
national regulations.
Turn the T-loc to one of this posi­
tions (Fig. ).
SYS-a
SYS-b