Maintenance & Cleaning - Lacor 69082 Instrucciones De Uso Y Mantenimiento

4.- When blending:
1.- Fruit gets ready (for example: cut apple, carrot or other fruit into pieces, then add
water, which don't exceed maximum line of mug. If crushed ice, please also add
some ice blocks, then cover the lid (11).
2.- Remove pusher )1), transparent cover (2), blade of juicing (3) and middle body (4)
firstly; then lay down the two lockers (6).
3.- Place glass mug onto main body, as per mark on main body (7), to switch on
safety awitch in main body. Otherwise, the motor doesn't work, if safety switch in
main body doesn't be switched on.
4.- Connect plug as per rated voltage, turn on switch (8), operate pulse switch (P)
3 or 5 times firstly, then spin to 1 speed (low) or 2 speed (high) for perfect effect,
suggest use pulse switch when ice crushing.
ATTENTION:
1.- The machine should be laid on a flat table or place when it is working, then operate it
according to the instruction manual.
2.- There is a safety protective switch; it cannot be worked until it is installed correctly.
3.- Don't work continuously over 1 minute. The appliance works again until it cools down
completely to prolong its service life.
4.- If the power cord was damaged, for safety please call for the professionals of the
manufacturer or special maintaining department to change it.
5.- The main body is not allowed to clean with water directly; wet cloths, soft brush or sponge
can scrub it.
6.- Operating by children is not admitted.
7.- Please put the juicer extractor in the dry and ventilative place if it is not used for a long time.
GENERAL
The Stainless steel extractor/food blender are designed for maximum durability and perform-
ance, with minimum maintenance
CAUTION
USE ONLY NON-ABRASIVE CLEANERS. ABRASIVE CLEANERS COULD SCRATCH THE
FINISH OF YOUR ST. STEEL EXTRACTOR/FOOD BLENDERMARRING ITS APPEARANCE
AND MAKING IT SUSCEPTIBLE TO SOIL ACCUMULATION.
CLEANING::
1.- Finish using, switch off and pull out plug, disassemble the parts (1,2,3,4,9,10) to wash them
by water, then dry and assemble again.
2.- Main body can't be cleaned by water, only wiped by wet cloth.
3.- In order to have a best extracting effort for each time, the filter net should be cleaned up
carefully after using.
MAINTENANCE & CLEANING
22