Resistance Test; Circuit Continuity Test - KPS -PA70 Manual De Funcionamiento

4.13 Resistance Test

Electric shock hazard. When measuring circuit impedance, determine
that the power supply is disconnected and the capacitor in the circuit
is completely discharged.
• Insert black probe to COM jack, insert red probe to INPUT jack.
• Place measuring range switch to
measurement state.
• Connect the probe to the both ends of resistor or circuit to be tested for
measurement.
• LCD will show readings.
NOTE:
1) When the input end is open, LCD shows "0L" outrange state.
2) When the resistance to be tested>1M, the meter reading will stablilizee after
a few seconds, which is normal for high resistance readings.
4.14 Diode test
• IInsert black probe to COM jack, insert red probe to INPUT jack.
• Measuring switch is placed to position
• Press "FUNC" key to switch to
• Connect the red probe to diode anode and connect the black probe to diode
cathode to make test.
• Read on the LCD.
NOTE:
1) What the meter shows is approximation of diode forward voltage drop.
2) If the probe has reverse connection or the probe is open, the LCD will show
"0L".

4.15 Circuit Continuity Test

When measuring circuit continuity, determine that the power supply is
disconnected and the capacitor in the circuit is completely discharged.
KPS-PA70 • Digital clamp meter
WARNING
position. At this time, the meter is in the
.
measuring state.
WARNING
44