Measuring Resistance - KPS -PA60 Manual De Funcionamiento

KPS-PA60 • Digital clamp meter
INPUT jack.
• Set the rotary selector to the V range.
• Press the "Hz/%" to switch to DUTY measurement.
• Connect test leads to the two end of the source or load for measurement.
• Take the reading on the LCD..
NOTE:
1) If the duty cycle is less than 10%, symbol „UL‟ will be displayed on LCD;
if the duty cycle is more than 94.9%, symbol „OL‟ will be displayed on LCD.
2) The input signal frequency range is 10 – 10 kHz. It is possible to test duty
cycle of the higher than 10 kHz frequency signal, but the tolerance of the test
result can not be ensure.
3) " " means the maximum input voltage is 600V rms AC.
4.14.3 By HZ/DUTY range:
• Plug the black test lead into the COM jack and the red test lead into the
INPUT jack.
• Set the rotary selector to the HZ/DUTY range position.
• Press the "Hz/%" to switch to DUTY measurement.
• Connect test leads to the two end of the source or load for measurement.
• Take the reading on the LCD..
NOTE:
1) If the duty cycle is less than 10%, symbol „UL‟ will be displayed on LCD;
if the duty cycle is more than 99.9%, symbol „OL‟ will be displayed on LCD.
3) The input signal frequency range is 10 – 10 kHz. It is possible to test duty
cycle of the higher than 10 kHz frequency signal, but the tolerance of the test
result can not be ensure.
3) " " means the maximum input voltage is 600V rms AC.

4.15 Measuring resistance

• Plug the black test lead into the COM jack and the red test lead into the
INPUT jack.
• Set the rotary selector to the
Ω range.
• Connect the test leads to the ends of the resistor or circuit for measurement.
• Take the reading on the LCD.
range position to makethe meter get into
43