Changing Operating Modes; Setting The Barking Detection Sensitivity - Num'axes CANICALM EXCEL Manual De Instrucciones

Changing operating modes


In the factory, the collar is set to mode Nr 2 (beep sound + light stimulation for sensitive dog).
To change the collar's mode, proceed in the following way:
When switching on the collar, keep the magnetic key in contact with the red mark located on the front
of the collar (See Diagram 3).
After the beep sound indicating that the collar is on, a series of beep sounds together with indicator
light flashes is emitted (from 1 to 4) indicating the selected mode.
Keep the magnetic key in contact with the red mark to run through modes.
Remove the magnetic key when you have reached the mode you wish. The collar will memorize your
selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you previously
selected.
The chart below indicates how your collar operates according to the mode you have selected:
Number of beep sounds together
with indicator light flashes emitted
when switching mode
1
2
3
4

Setting the barking detection sensitivity


Your dog's barking is detected by one of the contact points which sense the vibrations of his vocal
cords (See Diagram 1).
Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting
determines the correct operation of the product.
It ensures detection of any barking but helps avoid unnecessary detection. The detection must
therefore be sufficiently sensitive but not overly sensitive.
In the factory, detection sensitivity is set on level 5 (medium sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, turn the button located on the
front of the collar according to the sensitivity you wish (See Diagram 1).
Mode
Nr 1 Beep sounds only
Nr 2 Beep sound + light stimulation (sensitive dog)
Nr 3 Beep sound + progressive stimulation
Nr 4 Beep sound + strong stimulation (difficult dog)
Gb - 16
Operation