Changing operating modes
In the factory, the collar's mode is positioned on mode 2 (beep sounds + light stimulations).
To change the mode, the collar must be ready for use (battery in place).
Open the battery cover and find the button to change mode (See diagram 1).
Press the button using a pointed object (e.g. a screwdriver).
A series of beep sounds is emitted (from 1 to 4 beeps) indicating the selected mode.
Keep pressing the button to run through modes.
Release the button when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, it will be turned on to the last mode you previously selected.
The chart below indicates how your collar operates according to the mode you have selected:
Number of sound beeps heard
Setting the barking detection sensitivity
Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting
determines the correct operation of the product.
It ensures detection of any barking but helps avoids unnecessary detection.
The detection must therefore be sufficiently sensitive but not overly sensitive.
In the factory, detection sensitivity is set on the medium position (medium sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
- Remove the 4 screws from the battery cover.
- Remove the battery cover.
- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 1 and 2)
Caution: the adjustment system has a stop for the minimum sensitivity and a stop for the
maximum sensitivity. Turn delicately and without forcing with the supplied screwdriver.
- Replace the battery cover.
- Retighten moderately the 4 screws.
ide CANICALM Premium I 110x115.indd 13
when switching modes
1
2
3
4
Mode
1
Beep sounds only
2
Beep sounds + light stimulations
3
Beep sounds + strong stimulations
4
Beep sounds + increasing stimulations
Gb - 13
Operation
18/05/2017 08:4