Switching Off The Collar; Changing Operating Modes - Num'axes IKI PULSE Manual De Instrucciones

Bips sounds will be emitted and the red indicator light will flash indicating the collar has been switched on.
- Once the battery is fully charged, the red indicator light goes out to indicate that your product is completely recharged.
- Disconnect the collar from the charger.
- Disconnect the charger from the socket.
- Put the protection tab back in place making sure it is positioned correctly then press strongly to ensure it is engaged.
CAUTION : if the protection tab is badly repositioned or badly engaged, the waterproof fonction of your collar will be
compromised and you are likely to damage your product.
Switching on the collar
Briefly place (for less than 1 second) the magnetic key close to the orange mark located in front of the collar.
Beep sounds will be emitted and the red indicator light will flash indicating the collar has been switched on
The number of beep sounds and flashes is dependant on the selected mode (from 1 to 7).
Ex. : if the collar is in mode 3, 3 beep sounds will be emitted and the indicator light will flash 3 times when switching on the collar.
In the factory, the collar's mode is positioned on mode 2 (beep sounds + short stimulation for sensitive dog).

Switching off the collar

Briefly place (for less than 1 second) the magnetic key close to the orange mark located in front of the collar.
One long beep sound will be emitted and the red indicator light will flash once indicating the collar has been switched off.
Operation
At the first bark, a series of six beep sounds is emitted. If another bark is detected within 30 seconds, another beep sound of 2
seconds is emitted together with a static stimulation (short, long or progressive stimulation according to the selected operating
mode). Inhibition of any further stimulation is dependant on the absence of any barking within the next 30 seconds.
The stimulation function can be inhibited selecting operating mode 1. In this case, only beep sounds will be emitted.

Changing operating modes

In the factory, the collar's mode is set to mode 2 (beep sounds + short stimulation for sensitive dog).
To change the collar's mode, when switching on the collar you need to approach and keep the magnetic key in contact with the
orange mark located on the front off the collar.
A series of sound beeps is emitted (from 1 to 7) indicating the selected mode.
Diagram. 2
Protection tab
Gb - 14