Changing Operating Modes And Selecting Tones - Num'axes CANIBEEP PRO Manual De Instrucciones

Changing operating modes and selecting tones


CANIBEEP PRO allows you to locate one to four dogs at the same time (with four different
tones). Either when they are pointing, or when they are moving or pointing.
To change the tone emitted by your CANIBEEP PRO or to change operating modes, when turning
it on, you need to leave the magnetic key in contact with the magnetic switch position indicator
(position mark situated at the back of the collar under the NUM'AXES logotype - see diagram 4).
The collar emits a number of beep sounds (from 1 to 8).
Modes 1 to 8 run through as long as you leave the magnetic key in contact with the magnetic
switch position indicator.
Move the magnetic key away as soon as you have reached the desired mode: the collar will
memorize the configuration chosen. The next time you turn it on, CANIBEEP PRO will be in the
mode you selected last.
The table below shows how CANIBEEP PRO works according to the mode selected:
Number of
beeps
1 One beep every 2 seconds, tone N° 1
2 One beep every 2 seconds, tone N° 2
3 One beep every 2 seconds, tone N° 3
4 One beep every 2 seconds, tone N° 4
5 One beep every 2 seconds, tone N° 1
6 One beep every 2 seconds, tone N° 2
7 One beep every 2 seconds, tone N° 3
8 One beep every 2 seconds, tone N° 4
How the collar works

When on, and according to the mode selected, the collar may emit beep sounds when your dog
is not moving, if it has been still for at least 5 seconds. As soon as the dog moves, it is considered
moving.
GB - 20
Pointing dog Moving dog
No sound
No sound
No sound
No sound
One beep every 10 seconds, tone N° 1
One beep every 10 seconds, tone N° 2
One beep every 10 seconds, tone N° 3
One beep every 10 seconds, tone N° 4