Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION (Figure 1)
1
Carefully remove the Heater from the bag and the carton.
2
Place the Heater on a firm, level surface.
3
Plug the cord set into a
the red light will come on indicating that there is power to the unit. The red light will remain lit until the Heater is
unplugged from the electrical outlet.
4
Pressing the power button (
current room temperature will be displayed.
5
Once pressing the MODE button (
6
Pressing the MODE button (
7
Re-pressing the MODE button (
that the display now displays a SET TEMP indicator. (See Thermostat Instructions)
8
If you want to stop the heater working, press the power button (
9
Swing function: This function will work in any mode. Pressing the (
left and right. To stop the oscillation, press the Swing button (
10 Timer function: This function will work in any mode. The timer function allows you to set the length of operation
from 1 hour to 8 hours. Pressing the (
pressed till to 8h. Once the timer has been set, the timer will count down the hours in 1 hour increments, until the
heater will turn itself off. The operation time will be not displayed 10 seconds later after you finish set the working
time, the remaining operating time only will be showed till you press (
THERMOSTAT INSTRUCTIONS
1
Press the MODE button (
2
To adjust SET TEMP, press the ( ) to increase the desired temperature and the (
temperature.
3
When the air temperature raises 3 degrees above the set temperature, the heater will cut off after 20 seconds.
4
When the air temperature drops below the set temperature, the unit will come back on.
Note: It is normal for the Heater to cycle ON and OFF as it maintains the set temperature.
SAFETY FEATURES
1. A thermal overload protector is built in to prevent overheating.
2
When an overheat temperature is reached, the Heater will be automatically shut off.
SAVE THESE INSTRUCTION FOR FUTURE REFERENCE
230V
electrical outlet. When the Heater is initially plugged in, there will be a "beep" and
) (Figure 1) this heater will come into FAN mode, it will blow cool air, also the
), the unit will be in the LOW HEAT mode. (750Watts)
) again, the unit will be in the HIGH HEAT mode. (1500Watts)
) again, at this point will set the Heater into AUTO-SET TEMP mode. Notice
) button increase the length of operation by 1 hour each time the button is
) until the display shows AUTO Mode.
) again.
) once more.
) button again.
FIGURE 1
) button will allow the Heater to oscillate
) to decrease the desired
Publicidad
Tabla de contenido
