Toto SMA Kiwami Renesse TSKT Manual De Instrucciones página 8

10. Confirm that the distance between
finished wall and top of limiter collar
is between 1" (25mm) and 1-3/8"
(35mm).
If necessary, remove the spacer to
correct the distance.
Removing the Spacer
1. Remove the stem adjuster.
2. Unscrew the limiter collar.
3. Pull out the temperature limiter.
4. Remove the spacer.
5. Attach the temperature limiter
so that the center mark on
the limiter aligns with the top
center point on the valve.
6. Firmly tighten the limiter collar
and reattach the stem adjuster.
11. Remove plaster guard and clean the tile.
NOTE: Do not remove plaster guard
until tile work is completed.
inSTAllATion pRoCeDURe
8
Limiter Collar
Spacer
Loosen
Limiter collar
Stem adjuster
Tighten
Temperature limiter
Limiter collar
Stem adjuster
Plaster Guard
1" (25 mm) MIN
1-3/8" (35 mm) MAX
Temperature limiter
Mark faces up
Thermostatic
Mixing Valve