Ending Dvd Video Playback; Operating The Playstation; Dvd Player - Sony SCPH-10420E Manual De Instrucciones

Playing a DVD video (continued)
z Ending DVD video playback
1
Press the Z OPEN/CLOSE button on the DVD Remote Control or
the A (open) button on the console front.
2
Remove the disc.
3
Press the Z OPEN/CLOSE button on the DVD Remote Control or
the A (open) button on the console front.
The disc tray closes.
4
Press and hold down the I/1/RESET button on the DVD Remote
Control or the 1/RESET button on the console front for more than
three seconds.
The 1 indicator turns red and the console enters standby mode.
After changing DVD settings
To save changes made during playback, you must stop playback* or eject the DVD
before pressing the 1(standby)/RESET button on the console front or turning off
the console using the MAIN POWER switch on the console rear. Note that changes
will not be saved if you reset or turn off the console before stopping playback, or
without first ejecting the DVD.
* Stopping playback during Resume Play is included.
z Operating the PlayStation
The DVD player can be operated in the following three ways:
• directly with the DVD Remote Control
• through the on-screen Control Panel*
• directly with the Analog Controller (DUALSHOCK
* For details on playback options and operations that do not use the DVD Remote Control,
please refer to the PlayStation
Note
Some operations may vary or may not be available on some DVDs. For details, see the
instructions supplied with the DVD video in use.
8
2 console DVD player
®
2 console instruction manual.
®
2).*
®