Playback From The Last Stopping Point (Resume Play) - Sony SCPH-10420E Manual De Instrucciones

z Playback from the last stopping point (Resume Play)
The DVD player remembers the point where you stopped the disc, and you can
resume playback from that point.
1
During playback, press the x STOP button.
Playback stops, and the message, "Press [Play] to resume viewing. To start
from the beginning, press [Stop] and then [Play]." is displayed.
2
Press the H PLAY button
Playback resumes from the point where it was stopped in step 1.
To clear the last stopping point
After step 1, press the x STOP button again.
To clear Resume Play
If you resume playback after stopping, the DVD player enters Resume Play mode.
Many advanced settings for the DVD player are not available during Resume Play.
If you want to clear Resume Play to adjust settings, press the x STOP button twice.
Notes
• Resume Play may not be available on some DVDs or for some scenes.
• Depending on where you stop playback, the console may resume playback from a slightly
different point.
• The last stopping point is cleared and Resume Play is not available when:
– Program Play or Shuffle Play is selected.
– The disc tray is opened using the Z OPEN/CLOSE button on the DVD Remote Control
or the A (open) button on the console front.
– The console is reset or goes into standby mode after the I/1/RESET button on the DVD
Remote Control or the 1/RESET button on the console front has been pressed.
– The power is turned off using the MAIN POWER switch on the console rear.
– The x STOP button is pressed twice during playback.
GB
15