Installation And Start-Up - Cebora SYNSTAR 270 T Manual De Instrucciones

C
D
4 CONTROLS LOCATED ON REAR PANEL.
E
F
G
12
E – GAS PIPE CONNECTION.
F – SWITCH.
Starts and stops the machine
A
G – MAINS CABLE
B
I - FUSE HOLDER.
L – SOCKET.
H Socket which receives the power cord from the cooling
unit Art.1681 (optional).
M – PRESSURE SWITCH CONNECTOR.
Connector which receives the cable from the pressure
switch Art.1681 (optional).

5 INSTALLATION AND START-UP

Position the welding machine so as to allow the free circulation
of air inside and, as much as possible, prevent metal or other
dusts from penetrating.
• The machine must be installed by professional personnel.
• All the connections must be performed in compliance
with applicable standards (IEC/CEI EN 60974-9) and with
accident-prevention laws.
• Make sure the power supply voltage corresponds to the
welding machine rating.
• The protection fuses must be sized according to the details
shown on the technical data plate.
I
• P osition the cylinder on the support and fix it with the 2
straps; ensure that the straps are secured tightly to the
cylinder to prevent dangerous tilting.
• Connect the gas hose to the outlet of the pressure regulator.
• Open the side door.
• Connect the power cord to the socket D and through
M
the clamp to the workpiece.
• Connect the earth lead clamp D to the piece to be welded.
L
• Fit the wire coil on the support inside the compartment.
The coil must be fitted so that the wire unwinds in an
anticlockwise direction.