Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
E.
Quick-Connect Spray Wand: Allows the user to quickly change out
high pressure nozzles. See How To Use Spray Wand instructions in
Operation section.
F.
Detergent Tank: Feeds cleaning agents into the pump to mix with the
water. See How To Apply Chemicals/Cleaning Solvents instructions in
Operation section.
G. Handle
H. Frame
J.
Pump Outlet
K. Pump Inlet
L.
Quick Connect Nozzles
M. Nozzle Chart Label
N. Handle Knob
O. Spray Gun Holster
P.
Thermal Relief (not shown)
Q. Filter Screen (not shown)
R. Trigger Lock (not shown)
S.
Cleaning Tool (not shown)
T.
Water Source (not shown)
BASIC ELEMENTS OF AN ENGINE
Refer to the Engine Owner's Manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1.
Locate and remove all loose parts from the carton.
2.
Cut four corners of the carton from top to bottom and lay the panels flat.
3.
Place one hand on the handle (G) and one hand on the knob (N). Carefully pull
knob out and rotate the handle upward until it locks in place.
NOTICE: Risk of personal injury. Avoid placing hands between handle and frame
when assembling to prevent pinching.
4.
Mount the gun holster (O) to the upright frame tube using the saddle bolt and
knob provided.
FIG. 2
G
N
ASSEMBLY INSTRUCTIONS (FIG. 2–4)
O
11 - ENG
FIG. 2A
L
M
Publicidad
Tabla de contenido
