Simpson 7110274 Manual De Instrucciones página 13

PRESSURE WASHER OPERATING FEATURES
PRESSURE ADJUSTMENTS
The pressure setting is preset at the factory to achieve op ti mum pres sure
and cleaning. If you need to lower the pres sure, it can be accomplished by
these methods.
Back away from the sur face to be cleaned. The further away you are, the less
the pressure will be on the surface to be cleaned.
NOTICE: DO NOT attempt to increase pump pressure. A higher pressure setting
than the factory set pressure may damage pump.
HOW TO USE SPRAY WAND
The nozzles for the spray wand are stored in the nozzle holder on the panel assembly.
Colors on the panel identify nozzle location and spray pattern. Refer to the following
chart to choose the correct nozzle for the job to be performed.
CHANGING NOZZLES ON SPRAY WAND (FIG. 6)
DANGER: Risk of fluid injection. Do not direct discharge stream toward
persons, unprotected skin, eyes or any pets or animals. Serious injury
will occur.
WARNING: Flying objects could cause risk of serious injury. Do not
attempt to change nozzles while pressure washer is running. Turn engine off
before changing nozzles.
1. Pull quick-connect coupler (E) back and insert nozzle (L).
2. Release quick-connect coupler and twist nozzle to
make sure it is secure in coupler.
WARNING: Flying object could cause risk of serious
injury. Ensure nozzle is completely inserted in quick-
connect socket and quick-connect collar is fully engaged
(forward) before
NOZZLE COLOR
Red
Yellow
White
Black
squeezing
SPRAY PATTERN
0˚
15˚
40˚
low pressure
gun
USES
powerful pinpoint
for spot cleaning
of hard, unpainted
surfaces or for
high reach areas
intense cleaning
of unpainted
hard surfaces
cleaning of
painted or delicate
surfaces
applies cleaning
solutions
13 - ENG
FIG. 6
L
trigger.
SURFACES*
unpainted metal
or concrete;
DO NOT use on wood
grills, driveways, concrete
or brick walkways,
unpainted brick or stucco
auto/RV, marine, wood,
painted brick and stucco,
vinyl, painted siding
Low pressure
spray is safe on all
surfaces. Always verify
compatibility of cleaning
solution prior to use.
E