Skil PWR CORE 12 Manual Del Propietário página 13

Halo Light (Fig .5)
Your tool is equipped with a halo light, located
on the head of the tool; this provides additional
light without shadows on the surface of the
work piece for operation in lower-light areas.
The halo light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running and will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors
will turn the tool off and the halo light will flash
rapidly. Rest the tool for a while or place the
tool and battery pack separately under air flow
to cool.
The halo light will flash more slowly to indicate that the battery is at low-battery capacity;
recharge the battery pack.
Mode Selector (Fig .6)
Your tool is equipped with a speed-adjusting
interface to provide speed adjustment for 2
modes (low/high).
When the trigger is squeezed slightly, the mode
indicator will automatically shine green.
Depress the mode selector to adjust the speed
mode (Fig. 6).
One indicator light shines for "L" to indicate
"low-speed mode".
Both indicator lights shine for "H" to indicate
"high-speed mode".
The speed mode will be stored and applied
in the next operation when the tool is turned
on again or when the direction of rotation has
been changed. Reset the speed modes as desired.
NOTICE: To prevent gear damage, always allow the impact wrench to come to a complete
stop before changing between high speed and low speed. The speed mode can only be
changed when the mode-indicator light is on and the trigger switch is not depressed. The
mode selector cannot be activated when the motor is running. The mode-indicator light will
turn off automatically in about one minute after operation ceases.
Fig. 5
Halo Light
Fig. 6
Mode Selector Mode Indicator
13