Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Materials
Needed:
• '/4" outer diameter flexible copper tubing
• Shut-off
valve (requires a '/4" hole to be drilled into
water supply line before valve attachment)
• Adjustable
wrenches
(2)
• '/_" hex nut driver
Notes:
• Use copper tubing
only for installation.
Plastic is
less durable and can cause damage.
• Add 8' to tubing length needed to reach water
supply for creation of service loop.
.
Create service loop with copper
tubing
(minimum
2'
diameter).
Avoid kinks in
the copper tubing when
bending it into a service
loop. Do not use plastic
tubing.
2' diameter
minimum
2. Remove plastic cap from water supply connection.
.
Place brass nut 1:A) and sleeve 1:B)
on copper tube end as illustrated.
Reminder:
De net use an old sleeve.
The nut and sleeve are provided in
the Use and Care packet.
A
B
.
.
Place end of copper
tubing into water valve
supply line.
Slide brass nut over
sleeve and screw nut
into supply line.
I:1) Place adjustable
wrench on nut attached
to plastic waterline
and
maintain
position.
1:2) Using second
adjustable
wrench turn
the upper nut clockwise
and fully tighten while holding the lower nut in
place.
Important:
Do not over-tighten.
Cross threading
may
Occur.
2
1
tie
.
Pull on tubing to confirm
connection
is secure. Connect
tubing to frame with water
tubing clamp 1:0). Slide
waterline
into retainer, then
turn on water supply. Check
for leaks and correct if
necessary. Continue to
observe the water supply
connection
for two to three
hours prior to moving the refrigerator
to its
permanent
location.
7. Monitor water connection
for 24 hours. Correct
leaks, if necessary.
Opening and Closing Your
Fresh Food Doors
Your new refrigerator
is
uniquely designed
with two
fresh food doors.
Either door
can be opened or closed
independently
of one another.
For proper usage and to
avoid possible damage,
always ensure the vertical
hinged section (on the left
fresh food door) remains
folded inward before closing
both doors. When both doors
are closed, the hinged section
automatically
forms a seal between the two doors.
When the left door is opened, the vertical hinged
section automatically
folds inward so that is is out of
the way.
9
Publicidad
Tabla de contenido
