Maytag Ice2O MFI2568AEB Guía De Uso Y Cuidado página 8

Installation
To Install:
1. Pull both rails out to
full extension.
.
While supporting
door front, hook
supports into slots
located on inside of
each slide.
Note:
All four drawer bracket supports must be in
the proper slots for the drawer to function properly.
(See inset for detail.)
.
4.
.
.
Lower door front into final position.
Replace and tighten Phillips screws that were
removed from the drawer
slides.
Install the lower assembly
by aligning hooks of lower
drawer assembly with rear
rail on freezer drawer.
Replace freezer bins. Align
the large square notches
on outside of the drawer
slides.
Handles
Note:
If not installed, the handle is located in the
interior of the fresh food compartment or attached
to the back of your refrigerator.
Plastic Handle
To Remove:
1. Grasp the lower part of the handle
firmly, slide up, lift and remove
from the surface.
To Install:
1. The handles are to be oriented as
shown.
2. Align door handle clip with the
door studs.
3. Ensure the large hole in the
mounting clip is positioned
down on both ends of the
handle.
4. Rotate the handle so that the
handle is flat against the door.
5. Grasp the handle firmly and slide
down.
Freezer Handle
Notes:
• Select models have a slight
curve to the freezer handle.
• For proper installation, be sure
handle is oriented as shown.
Stud