Config Mode - Promax -27 Manual De Uso

USER'S MANUAL. PROMAX-27
- BATTERY:
- FIRMWARE:
- SERIAL NUMBER:

4.2.2 CONFIG Mode

To access the CONFIG mode for setting the general configuration of the system:
1.- Press key
2.- Press softkey CONFIG [F4].
It appears the screen with configuration parameters (Figure 6.-).
This menu allows you to set the parameters in order to the instrument can take
the TV digital and analog measurements, as well as the data analysis for upstream and
downstream.
To change a parameter:
1.- Use the cursor keys
2.- Go to the parameter you want to modify and press the selection key
3.- The cursor will move next to the parameter value. Now you can change that
value using the cursor or the alphanumeric keypad (depending on the case).
4.- After you have made your changes, press again the selection key
save changes.
09/2010
Indicates the battery charge in voltage.
Indicates control program version.
It is a unique identifier number for the instrument.
[13]
Figure 6.- CONFIG menu.
[7] to scroll through the menu.
[8].
[8] to
Page 17