Connections And Wiring; Connection Overview - Eaton xChargeIn Manual De Instalación

Ocultar thumbs Ver también para xChargeIn:

Tabla de contenido

Idiomas disponibles

Connections and wiring

The following illustration shows a connection overview with the covers open.

Fig. 7-15: Connection overview

Risk of electric shock and fire hazard!

● For terminals X1-X4 (Ethernet connections as well as terminals for en-

● The connection panel is never permitted to be left open unattended. Be-

Installation manual V1.01

... Fuse holder

... Mains connection phase conduc-

... Mains connection neutral conductor

... DIP switch

... Service button

... Enable input

... Shield clamp (mass for ETH)

... Ethernet1 connection (LSA+® ter-

... USB interface

abe input and switch contact output), only voltages and circuits are per-

mitted to be connected which have a safe separation to dangerous volt-

ages (for example sufficient insulation).

Supply the terminal for the switch contact output (X2) exclusively from

voltage sources which have a protective extra-low voltage.

fore leaving the charging station, the connection panel cover must be

Connections and wiring

... Mains connection phase conduc-

... Mains connection phase conduc-

... Mains connection earthing conduc-

... DIP switch

... Status LED

... Switch contact output

... Ethernet2 connection (RJ45)

... SIM card slot (optional)

Tabla de contenido