Commissioning; Activating/Deactivating Commissioning Mode - Eaton xChargeIn Manual De Instalación

Commissioning

9 Commissioning
The inspections and tests to be performed on the electrical connections and
the correct functioning up to the acceptance of the charging station (in accor-
dance with the locally applicable directives and laws) may only be carried
out by a qualified electrician.
The following work must be carried out at the start of commissioning:
●
●
●
●
The following steps are necessary during the initial commissioning:
●
●
●
●
●
9.1

Activating/deactivating commissioning mode

The charging station can be put into a special commissioning mode to help
facilitate the system inspection. The device carries out an extended self-test
(interlocking, contactor control, current measurement, ...). Furthermore, the
contactor is switched on with a time limit, to facilitate initial testing in this
mode, even without a vehicle being plugged in. The charging socket is
locked to prevent a cable from being plugged in.
A normal charging process is not possible in commissioning mode.
Information
For safety reasons, the commissioning mode is indicated on the charging
station by an orange display on segment S3 of the LED bar (-/-/orange/-).
44
Remove all residual installation and connection materials from the con-
nection area.
Check all screw and clamp connections for tightness.
Check that all unused cable screw connections are properly sealed with
blind plugs or dummy screw fittings.
Switch on the voltage of the supply line. After 15-20 seconds, the LED
bar should flash slowly blue or green. This indicates that the self-test,
which is performed automatically at each startup, was successful.
Activate commissioning mode
Perform safety checks
Deactivate commissioning mode
Mount covers
Attach seal
xChargeIn
Installation manual V1.01
© EATON