Attach Seal - Eaton xChargeIn Manual De Instalación

Ocultar thumbs Ver también para xChargeIn:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 249
Commissioning
9.4

Attach seal

Depending on the scope of delivery, devices are available for sealing the ter-
minal cover and the connection panel cover. If required, these can be used
to prevent or identify tampering attempts by unauthorized persons at charg-
ing stations with preconfiguration or special suitability (MID calibration valid-
ity).
To attach the seals, proceed as follows:
1) If necessary, open the covers of the charging station until the cover to be
2) Loosen the right upper screw of the cover to be sealed.
3) Insert the screw into the sealing cap.
4) Screw the screw with the sealing cap back into the cover.
5) Close the cover of the sealing cap.
6) Thread the sealing wire through the opening of the sealing cap over the
The seal is attached. If necessary, reinstall all other covers of the charging
station.
48
sealed is accessible.
screw and place the seal.
xChargeIn
Installation manual V1.01
© EATON

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido