Syncing Two Bases - Serta motion plus Manual De Uso

syncing two bases (optional)
A Sync Cord is included with the base. Not available on Queen, Full, Full-Long, or Divided King size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 1
Unplug bases from power source.
STEP 2
Disconnect the Power Down Box cable from each Control
Box or splitter cable. Make note where the cable was
plugged in.
STEP 3
Connect the male end of each Sync Cord to Control
Box or splitter cable. Insert it into the same port that you
disconnected the Power Down Box from in Step 2.
STEP 4
Connect each Power Down Box male connection to the
sync cord female connection (refer to illustration at right).
STEP 5
Plug bases back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both remotes
will now operate both bases simultaneously.
The system is now linked. Buttons pressed on either remote
will control both bases simultaneously.
Control Box 1
Splitter Cable
Power Down
Box 1
PERFORMANCE NOTES
If bases become mismatched, pressing the FLAT button will re-
sync the mechanical positions.
Control Box 2
Sync Cord
Splitter Cable
Power Down
Box 2
15