4. Use/Operators
4.1 Proper use
The drive unit is to be used exclusively for controlling linear shafts or other adjustment tasks of a
comparable kind.
The drive unit should not be used in areas where there is a risk of explosion or in direct contact
with foodstuffs, pharmaceutical or cosmetic products.
Catalogue information, the contents of these installation instructions and/or conditions laid
down in the order are to be taken into account.
The values given in these installation instructions are maximum values and must not be exceeded.
4.2 Improper use
Improper use means that the information quoted in the Proper use section is not being observed.
In the event of improper use, incorrect action and if this drive unit is used, installed or handled by
untrained personnel, this drive unit may pose risks for them.
Moving personnel with this drive unit is an example of improper use and is prohibited.
If this drive unit is used improperly, then RK Rose+Krieger GmbH ceases to be liable and its gen-
eral operating licence will be void.
4.2.1 Reasonably predictable improper use
•
Overloading the appliance by exceeding the weight or ED
•
Use in the open air
•
Use in an environment with air humidity > dewpoint
•
Use in room with an explosive atmosphere as defined in the ATEX directive
•
Open the equipment
•
Use with damaged feed lines or housing
A potential malfunction of the limit switch is to be prevented by its design. Lateral forces must not
lead to toppling. No risk must arise if the mains plug is pulled out.
4.3 Who can use, install and operate this drive unit
Individuals who have read and understood the installation instructions completely can use, install
and operate this drive unit. Responsibilities for handling this drive unit must be clearly laid down
and obeyed.
32