5.7.7 Profibus/Ethernet (option)
The controller can be optionally equipped with Profibus or
Ethernet.
Profibus-DP module
The Profibus-DP connection is made via a 6-pin plug.
Fig. 13 Profibus connection diagram
Plug
Signal
0
RTS (CNTR-P/RTS) Control signal for repeater
1
PGND
2
RxD/TxD-N
3
RxD/TxD-P
4
DP GND
5
DP 5 V
CNTR-N
Ethernet TCP/IP
•
Ethernet 10 Base-T/100 Base-TX (10/100 MBit/s).
•
Transport protocol TCP or UDP connection.
•
The connection is made using an RJ 45 plug of category 5.
Description
Shield/protective earth
Received data/transmitted data
Negative
Received data/transmitted data
Positive
Ground to DP 5 V
5 V supply for terminating
resistors
Control signal for repeater
5.8 Interfaces RS-232, -422 and -485
The controller can optionally be equipped with interfaces.
5.8.1 Connection of RS-232 interface
Fig. 14 Connection diagram of RS-232 interface
5.8.2 Connection of RS-422 and -485 interfaces
Fig. 15 Connection diagram of RS-422 and-485 interfaces
19