Turning Off The Machine - Canon JX510P Guia Del Usuario

Turning the Machine ON and OFF
Turn on the machine before using.
Turning on the Machine
Before turning on the machine, confirm that the FINE Cartridge is set into place.
Note
If preparatory operations are not yet finished, follow your setup sheet to complete them.
1
To turn on the machine, press [ON].
[ON] flashes green for a while, and then turns on.
Note
If an error message is displayed on the LCD, see "LCD Messages" on page 85.
When the machine is left inactive for more than 4 minutes 30 seconds, the LCD goes off
automatically and the machine enters the power saver mode. Press any button on the
Operation Panel except for [ON] to restore the display.

Turning off the Machine

1
To turn off the machine, press [ON].
The machine is off after <SHUTTING DOWN...> is displayed on the LCD.
Important
Always turn off the machine before disconnecting the power cord. This ensures the FINE
Cartridge is covered to prevent it from drying out.
If the machine is not used for an extended period of time, we recommend making copies or
performing FINE Cartridge cleaning about once every month to prevent degradation of the FINE
Cartridge.
The FINE Cartridge has many nozzles in order to produce high-definition prints. In the same
way that the tip of a felt-tip or marker pen will naturally dry out over time and become unusable
even with the cap in place, the nozzles might become clogged. Periodically printing or
performing FINE Cartridge cleaning can help to prevent this kind of clogging.
If you change to another telephone line, turn off the machine before unplugging the telephone
line cable.
Note
The power cannot be turned off with [ON] while the machine is operating.
12 Before Using Your Machine