Canon JX510P Guia Del Usuario página 86

Printing Stops Before It Is Completed
Cause
Printing documents with plenty of
photographs or illustrations.
The machine has been printing
continuously over a long period.
Paper may not be loaded correctly.
Printing Speed Not as Fast as Expected
Note
Printing speed may not improve noticeably by following the instructions below, depending on your
system environment.
Cause
Print quality is set too high.
Printer Status Monitor Is Not Displayed
Cause
Printer status monitor is not enabled.
The Inkjet Printer/Scanner/Fax Extended Survey Program Screen Is
Displayed
If the Inkjet Printer/Scanner/Fax Extended Survey Program is installed, the confirmation screen
asking to send the machine usage information will be displayed three months and then six
months after the installation. After that, it will be displayed every half a year for about four years.
Printing large data such as photos or graphics takes time for the machine and
the computer to process, during which the machine may appear to have
stopped operating.
In addition, when printing data that uses a large amount of ink continuously on
plain paper, the machine may pause temporarily. In either case, wait until the
process is complete.
Note
If you are printing a document with a large printing area or printing multiple
copies of a document, printing may pause to allow the ink to dry.
If the machine has been printing continuously for a long time, the Print Head
may overheat. To protect the Print Head, the machine may stop printing at a line
break for a period of time and then resume printing.
In this case, interrupt your print session at a convenient time and turn the
machine off for at least 15 minutes.
Additionally, if the machine has been printing graphics or photos with intense
colors continuously over a period of time, the machine may stop printing to
protect the Print Head. In this case, printing will not resume automatically. Turn
the machine off for at least 15 minutes.
Caution
The Print Head and the surrounding area can become extremely hot inside the
machine. Never touch the Print Head or nearby components.
Make sure that paper is loaded in the Rear Tray.
If the machine has run out of paper, load paper.
Change the print quality setting appropriately in the printer driver.
(1)Open the printer properties dialog box.
Refer to the On-screen Manual.
(2)On the Main sheet, select Standard or Draft for the Print Quality setting.
Make sure that Enable Status Monitor is selected on the Option menu of the
printer status monitor.
(1)Open the printer properties dialog box.
Refer to the On-screen Manual.
(2)On the Maintenance sheet, click View Printer Status.
(3)Select Enable Status Monitor on the Option menu if it is not selected.
Action
Action
Action
Troubleshooting 83