Important Safety Instructions; Installation; Power Supply - Canon ImageRunner advance 6275i Guía De Usuario

Important Safety Instructions

Please read these "Important Safety Instructions"
thoroughly before operating the machine. As these
instructions are intended to prevent injury to the user
or other persons or destruction of property, always pay
attention to these instructions. Also, since it may result
in unexpected accidents or injuries, do not perform any
operation unless otherwise specifi ed in the manual.
Improper operation or use of this machine could result
in personal injury and/or damage requiring extensive
repair that may not be covered under your Limited
Warranty.

Installation

•
Never block the ventilation slots and louvers on the
machine. These openings are provided for proper
ventilation of working parts inside the machine.
Blocking these openings can cause the machine to
overheat. Never place the machine on a soft surface,
such as a sofa or rug.
•
Do not install the machine in the following
locations:
-
A damp or dusty location
-
A location near water faucets or water
-
A location exposed to direct sunlight
-
A location subject to high temperatures
-
A location near open fl ames
•
Do not install the machine near alcohol, paint
thinner, or other fl ammable substances. If
fl ammable substances come into contact with
electrical parts inside the machine, it may result in a
fi re or electrical shock.
•
Do not place the following items on the machine. If
these items come into contact with a high-voltage
area inside the machine, it may result in a fi re or
electrical shock. If these items are dropped or
spilled inside the machine, immediately turn OFF
the main power switch, and disconnect the power
cord from the power outlet. Then, contact your local
authorized Canon dealer.
-
Necklaces and other metal objects
-
Cups, vases, fl owerpots, and other containers fi lled
with water or liquids
1
•
Do not install the machine in unstable locations,
such as unsteady platforms or inclined fl oors, or in
locations subject to excessive vibrations, as this may
cause the machine to fall or tip over, resulting in
personal injury.
•
Do not remove the machine's leveling feet after the
machine has been installed, as this may cause the
machine to fall or tip over, resulting in personal
injury.

Power Supply

•
Do not damage or modify the power cord. Also,
do not place heavy objects on the power cord, or
pull on or excessively bend it, as this could cause
electrical damage and result in a fi re or electrical
shock.
•
Keep the power cord away from a heat source;
failure to do this may cause the power cord coating
to melt, resulting in a fi re or electrical shock.
•
Do not connect or disconnect the power cord with
wet hands, as this may result in electrical shock.
•
Do not connect the power cord to a multiplug power
strip, as this may cause a fi re or electrical shock.
•
Do not bundle up or tie the power cord in a knot, as
this may result in a fi re or electrical shock.
•
Insert the power plug completely into the power
outlet, as failure to do so may result in a fi re or
electrical shock.
•
Do not use power cords other than the power cord
provided, as this may result in a fi re or electrical
shock.
•
As a general rule, do not use extension cords. Using
an extension cord may result in a fi re or electrical
shock.
•
Do not use power supplies with voltages other than
those specifi ed herein, as this may result in a fi re or
electrical shock.
•
Always grasp the power plug when disconnecting
the power cord. Pulling on the power cord may
expose or snap the core wire, or otherwise damage
the power cord. If the power cord is damaged, this
could cause current to leak, resulting in a fi re or
electrical shock.
Preface 13