Print Setup Of Rs232/2Nd Rs232 - OHAUS Defender 5000 Manual Del Usuario

EN-30
3.9.1.3 Stop Bits
Set the stop bits.
1 BIT
2 BIT
3.9.1.4 Handshake
Set the flow control method.
NONE
XON/XOFF
HARDWARE
3.9.1.5 Alternate Print Command
Set the alternate command character for Print.
Settings of A(a) to Z(z) are available. The default setting is P.
3.9.1.6 Alternate Tare Command
Set the alternate command character for Tare.
Settings of A(a) to Z(z) are available. The default setting is T.
3.9.1.7 Alternate Zero Command
Set the alternate command character for Zero.
Settings of A(a) to Z(z) are available. The default setting is Z.
3.9.1.8 Reset
Reset the settings to factory default.

3.9.2 Print Setup of RS232/2nd RS232

3.9.2.1 Demand
If Demand is selected, the sub-menu Stable Only will display.
Set the printing criteria.
OFF = values are printed immediately, regardless of stability.
ON = values are printed only when the stability criteria are met.
Note: For more detailed information, please refer to Section 5.3 Printout.
3.9.2.2 Auto On Stable
If Auto On Stable is selected, the sub-menu Mode will display.
Set the printing mode.
Load
Load and Zero = Prints when the displayed load and zero reading is stable.
3.9.2.3 Auto On Accept
If Auto On Accept is selected and the weighing mode is Check, values will be printed when the weight
is accepted.
ACCEPT = printing occurs each time the display is within the Checkweigh accept
range and stability criteria are met.
3.9.2.4 Interval
If Interval is selected, the sub-menu Time will display.
INTERVAL = printing occurs at the defined time interval.
The time interval can be set through the numeric keypad.
Settings of 1 to 3600 seconds are available. Default is 0.
Printing occurs at the defined time interval.
= no handshaking
= XON/XOFF handshaking
= hardware handshaking (COM1 menu only)
= Prints when the displayed load is stable.
Defender 5000 Indicators