Check; Check Weighing (Default) - OHAUS Defender 5000 Manual Del Usuario

Defender 5000 Indicators
Press the button
With the button corresponding to the icon
down the list and highlight Application Mode.
Enter this sub-menu by pressing the button
corresponding to the icon
In the Application Mode menu enter the
Counting sub-menu.
Select the list item and press the button
corresponding to the icon
setting as desired. After completion of I/O's
setup, press the Softkey corresponding to the
icon to return to the main application
screen.

4.3 Check

Check is used to compare the weight or pieces of a sample against target limits.
Press the button
Two different modes can be selected in the Check Mode: Weighing, Counting.
Setup check limits according to section 4.3.1 or 4.3.2. Place object on the pan to check if the weight
is within the limits.

4.3.1 Check Weighing (default)

Make sure that the Check mode is set to Check
Weighing in the configuration menu.
Place objects on the pan. The Under/Accept/Over
status is shown in the progress bar area while the
actual weight of the item is shown on the main
Display Line.
Defining Over/Under Limits
Press the button Edit Limit to define the limit for
weighing.
Select Over or Under Limit and press the button
corresponding to the icon
to enter the Main Menu.
, go
.
to change the
until the icon corresponding to Check is displayed in the screen.
to edit the value.
EN-39