Input/Output (I/O) Setup - OHAUS Defender 5000 Manual Del Usuario

Defender 5000 Indicators

4.1.5 Input/Output (I/O) Setup

The I/O's setup can be customized for various user preferences.
The I/O's setup is defined below (defaults in Bold).
Item
Enable
Discrete Input 1
Discrete Input 2
Discrete Output 1
Discrete Output 2
Discrete Output 3
Discrete Output 4
Note: The I/O's will only work when the I/O Option Board has been installed. See the Accessory list
in section 9.4 for information.
The option I/O board provides two isolated inputs and four dry-contact normally open relay outputs
which can be used for simple process weighing.
Press the button
With the button corresponding to the icon
down the list and highlight Application Mode.
Enter this sub-menu by pressing the button
corresponding to the icon
In the Application Mode menu enter the Weighing
sub-menu.
The Weighing sub-menu is now displayed.
Select the list item and press the button
corresponding to the icon
setting as desired. After completion of I/O's
setup, press the Softkey corresponding to the
icon to return to the main application
screen.
Available Settings
On, Off
Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Off, Overload, Underload
Off, Overload, Underload
Off, Overload, Underload
Off, Overload, Underload
to enter the Main Menu.
.
to change the
, go
EN-35