How Does My Landroid; Finding The Charging Base; Rain Sensors; Sensing The Boundary Wire - Worx Landroid S Basic Manual Del Propietário

5.2 How does my Landroid

®
Your Landroid is capable of doing things on its own. The Landroid
charge, can sense when it is raining, can stop itself if it senses a problem, and knows to stop, draw back, and turn around
when it bumps into something blocking its path. The Landroid
rotating if it is lifted off the ground to prevent an accident.
A. Finding the charging base
When your Landroid
direction back to its Charging Base. Landroid
By default, Landroid
B. Rain sensors
®
The Landroid is equipped with a Rain Sensor (7) which detects rain
and tells the Landroid
Wire back to its Charging Base (See Fig. B).
®
Landroid will resume mowing after passing the Delay Time. The
default Delay Time is 180mins.
When the rain sensors are wet, the Landroid
base. The error indication light will flash blue four times per cycle.
When the rain sensors dry, Landroid
countdown or return to mowing. If you want to exit from the rain
delay, dry the sensor area, and perform a power cycle by operating
the Main Switch. After the power cycle has been performed you can
see that the blue led is not flashing and so you can operate again.
C. Sensing the boundary wire
®
The Landroid always obeys the border set by the Boundary Wire and uses sensors at its front to detect it. (See Fig. C).
D. Starting and stopping while mowing (See Fig. D, E1, E2)
If you would like Landroid
the main switch to "I" (on), wait until the battery indication light stays green. Press
10
low battery capacity, the battery indication light will stay red.)
®
If Landroid senses something is wrong, the error indication light will indicate the fault message. For information on these
messages, refer to the Error Messages." Landroid
To resume:
• Turn the Main switch (8) to "O"(off)
• Correct the problem (refer to Error Messages)
• Turn the main switch (8) to "I"(on), Wait until the battery indication light stays green. (If Landroid
capacity, the battery indication light will stay red.)
• Press , then press
• Now the Landroid
C
Owner's Manual of Lawn Mowing Robot EN
®
needs to recharge, it will stop mowing and follow the Boundary Wire (17) in an anti-clockwise
®
is pre-programmed to mow the grass near the boundary wire once a week.
®
will mow near the boundary wire at a random time during the next week after it is powered on.
®
to stop mowing and follow the Boundary
®
returns to its charging
®
will begin the Delay Time
®
to stop mowing, simply press the STOP button (9) on top of the mower. To start mowing, turn
®
®
will begin to mow!
®
know what to mow?
®
knows when it needs to go to its Charging Base (3) to
®
will also automatically stop its Blade Turning Disc (13) from
B
will turn off if it does not receive any input from the user within 20 min.
D D
, then press . ( If Landroid
®
has low battery
®
has