Replace The Blades; Keep It Clean; Cleaning The Body; Cleaning The Underside - Worx Landroid S Basic Manual Del Propietário

turning disc. Failure to use new screws could cause
serious injury.
®
The Landroid does not cut grass like other mowers. Its Cutting
Blades (12) are razor sharp on 2 edges and rotate in both
directions for maximum cutting capacity (See Fig. L). Each blade
®
of your Landroid
make forward and reverse rotation at random to use both cutting
edges and minimize the frequency of replacing the blades. Each
cutting blade will last up to 2 months when it is programmed to
mow everyday. Always check to see if the Blades are chipped
or damaged and replace them if they are. When the cutting
blades are dull and worn out, they should be replaced with the
spare blades provided with your Landroid
available at your nearest WORX retailer.
A. Replace the Blades
After some time, usually every season, your Landroid
will need to be replaced. When replacing the Blades, make sure
to replace all of them at the same time. You can replace them with
one of the spare Blade kits and extra Blade screws supplied with
®
your Landroid .
Before attempting to replace your Landroid
power off and put on protective gloves and follow these steps:
1. Gently flip the Landroid
2. Remove the battery cover and remove the battery.
3. Take the screws off the Blades with a screwdriver (See Fig. M)
4. Firmly screw on the new Blades.
5. Refit the battery and the battery cover.
IMPORTANT: After screwing the Blade to the Blade
Disc, make sure the Blade is able to spin freely.
14

8.2 Keep it clean

WARNING: Before cleaning, turn your Landroid
OFF. Put on protective gloves before cleaning the
Blade Turning Disc (13) and do not rinse or flush with
water.
A. Cleaning the body
®
Your Landroid will live a much happier and longer life if it is
cleaned regularly. Although, since your Landroid
machine, you will need to take care when cleaning. DO NOT
use a hose, high pressure washers or otherwise pour
running water on your Landroid
bottle filled with water. When cleaning the machine body, use a
soft brush or clean cloth and avoid using solvents or polishes (See
Fig. N). Lastly, remove all build up of grass clippings and debris.
B. Cleaning the Underside
Again, it is important that you power the Landroid
Disc (13).
First, flip your Landroid
Front Wheel (11) and Driving Wheels (6). Clean everything thoroughly with a soft brush or moist rag.
WARNING: NEVER clean the underside of Landroid
Fig. O1, O2)
Rotate the Blade Disc to ensure it rotates freely. Check the blades spin freely around the fixing screws. Remove any
obstructions.
IMPORTANT: Remove any lodged debris so that it does not cause a crack in the Blade Disc. Even the
tiniest crack can decrease your Landroid
C. Clean the contact pins and the charging strips
Clean the Contact Pins (2) located on the Charging Base (3) and the Charging Strips (4) located on the Landroid
cloth. Remove any built up grass clippings or debris around the Contact Pins and charge strips periodically to ensure the
®
Landroid successfully charges each time.
Owner's Manual of Lawn Mowing Robot EN
has 2 cutting edges. The Blade Turning Disc will
®
. Spare blades are also
®
's Blades, turn the
®
over.
®
. It is best to use a spray
®
upside down to expose its underside. Here you will see the Blade Disc, the chassis, and the
L
®
's Blades
M
®
®
is an electric
N
®
OFF and wear protective gloves before touching the Blade Turning
®
with running water. Component damage can occur. (See
®
's mowing output.
1
2
®
using a